• facebook
  • googleplus
  • linkedin
  • twitter
  • youtube

Guide to replace Domino 37733 viscometer


1. Firstly Domino Power Supply should cut off.

2.From Domino CIJ printer interface board you need to remove the damaged Domino viscometer.

3.In the viscometer find and remove the ink tube connector.

4.Must carry out some protective measures, may be there will be ink leaking out.

5.Then Install the new Domino viscometer and well connect the ink tube.

 6.The interface board should Connect to Domino viscometer cable.

7.When you done with all installation steps check it.

8.In end switch on power supply again, see machine and open it.

9. Lastly thoroughly review that whether viscometer can able to test viscosity value of the ink or not.


Post time: May-21-2018